1 English review written for Micro-Swiss CM2™ RepRap Nozzle 1.75mm

How has this not caused a bigger splash?

Rated with 5 out of 5 stars.

Been using this nozzle non-stop since I bought it, and well... how is this costing only 25E?

The non-stick coating works like a charm, printing even the stringiest polyesters with little problem- and any buildups very easy to remove afterwards (I heat the hotend to some 100C, then slowly pull off the plastic with pincers into a string)

The copper construction (together with the Dragon HF its installed on) means temperatures 10C lower than I had to use previously;

and as for durability- not sure if people realise this, but the steel insert is advertised with 4 HRC points higher hardness than the fabled Vanadium nozzle from Slice.
For 40% less than the NozzleX (and like 80% less than Vanadium) and having night and day better thermal performance.

I war originally suspicious of composite nozzles, but this (together with the aforementioned Dragon) survived on overhang crash hard enough to cause a 1cm layer shift with no problem, so no complaints there either.

All in all seems like the top down best nozzle on the market, can we please get more manufacturers make such good products for such a price?

Was this rating helpful? Yes (13) No (0)