BondTech IFS Extruder Upgrade Kit for the Prusa Mini

Upgrade the extruder of your Prusa Mini / + to use the functions of the new, internal filament sensor!

Use this set of parts to make the original extruder on your Prusa Mini compatible with IFS (Internal Filament Sensor). It will change the front housing of the Prusa Mini extruder so that the new filament sensor for Prusa Mini / + can be mounted in it.

Compatible with filament sensor

The Bondtech Internal Filament Sensor Extruder for the Prusa Mini can embed the new Prusa filament sensor for Mini or Mini + in its front housing. However, the extruder can be used with or without a filament sensor.

The front housing of the IFS extruder for Prusa Mini contains a plug that is just a placeholder for the steel ball of the filament sensor and enables the extruder to be used without a filament sensor. If you want to use the IFS extruder with the Prusa filament sensor, remove the connector and follow the instructions to install all of the required accessories.

Included in this kit

• 1x 10076-3 front housing (PA12)
• 1x 10076-4 IFS magnet holder (PA12)
• 1x 10076-5 IFS lever (PA12)
• 1x 15112 IFS extruder plug (HT-PLA)

Not included in this kit

• Prusa filament sensor
• Filament sensor magnets
• Filament sensor steel ball